Hack’s Hardcore Hints #10: Artillery and Firebases

mpaign Series Vietnam | Hack's Hardcore HintsIn Hack's Hardcore Hints series, David Galster shares some of his scenario design toolkits for Campaign Series: Vietnam, a work-in-progress tactical platoon-scale wargame.

It’s a pleasure, Campaign Series Wargamers,

Did you ever imagine that there were upwards of 8000 firebases established in Vietnam between 1945 and 1975? Naturally, "only" a couple thousand were active at any one time. Let that sink in.

This article covers US artillery in Vietnam in more detail, and describes the important role that fire support bases played in the war.

Organization

Over half the artillery units were under division artillery or DIVARTY. Infantry divisions typically had three 105mm howitzer battalions, and one 155mm/8in. howitzer battalion.

Artillery battalions all had a headquarters plus a headquarters and service battery (HHSB). This included operations, fire direction, administrative, service, liaison, medical sections, communications, plus supply and maintenance platoons.

Field artillery battalions had three batteries, (A, B, & C) with the exception of 155mm/8in. howitzer battalions. These had three 155mm towed howitzer batteries, and one battery of 8in. SP howitzers. Towed and SP 105mm and 155mm howitzer batteries had six tubes. Eight-inch SP howitzer and 175mm SP gun batteries had four tubes.

Sometimes 105mm battalions formed a provisional Battery D (Delta) to adapt to operational needs. Typically, two howitzers were drawn from each of two regular batteries. Crews were smaller, and headquarters personnel were drawn from the headquarters battery and/or other howitzer batteries. One unique organization was Battery D, 2nd Battalion, 13th Artillery of II FFV Artillery. Known as the "Jungle Battery," it had three 105mm, and three 155mm howitzers. It supported Special Forces in III and IV CTZ.

A total of 63 towed and SP 105mm, 155mm, 175mm, and 8in. battalions served in Vietnam. There were also four separate 105mm batteries, five target acquisition batteries, two aerial rocket battalions and two batteries (rocket-firing helicopters), and two aviation batteries (observation helicopters). These units were assigned to field force/corps and division artillery, separate brigades, and artillery groups.

The "Guns"

The main calibers were 105mm, 155mm, 8 in. and 175mm. The 105mm was the most common, and the initial model was M101A1. This howitzer was virtually the same 105mm that had been used by US forces since World War II.

In 1966, a new 105mm towed howitzer, the M102, was received in Vietnam. Replacement of the old howitzers continued steadily over the next four years. Many seasoned artillerymen did not want the old cannon replaced. They had become familiar with its every detail, and were confident using it.  The waist-high breech made it easier to load, and it had higher ground clearance when towed.

However, the M102 was substantially lighter, weighing little more than 1.5 tons, whereas the M101A1 weighed approximately 2.5 tons. So, more ammunition could be carried during heliborne operations, and a 3/4-ton truck rather than a 2½-ton truck was its prime mover for ground operations. Another M102 advantage was that it could be traversed a full 6400 mils. (360°)

The towed M114 155mm howitzer was the medium duty weapon. The 155mm self-propelled (SP) version was the M109.

The 8 in. (heavy) howitzer was self propelled, and known as the M110. The M107 175mm self- propelled howitzer was another large gun in the "heavy" category.

US Artillery Systems used in Vietnam

M101A1-105mm-Howitzer

M101A1-105mm-Howitzer

M102-105mm-Howitzer.

M102 105mm Howitzer

M114 155mm Howitzer

M114 155mm Howitzer

M110-8in.-Howitzer-SP

M110-8in.-Howitzer-SP

Fire Support Bases

So, just what does the term "firebase" or "fire support base" mean? Any position with heavy weapons could fall in this classification, but it had a more definite meaning in Vietnam. To better understand this, there were several types of bases.

The largest was the "base camp." These were permanently fortified, and were the headquarters for large organizations like divisions or corps. They typically had an airfield, capable of landing large fixed wing aircraft.

A "forward operating base" (FOB) was smaller than a main base, but was also permanently fortified and had an airfield. A division or a brigade task force sized unit could have a headquarters here.

The "fire support base" FSB was smaller than an FOB. The fortifications were fairly permanent, but the LZ was for helicopters (Chinook) rather than fixed-wing aircraft. These typically housed a single artillery battery, and were often the headquarters for an infantry battalion operating in the area.

A "landing zone" or (LZ) could be anywhere needed to land helicopters. Most were temporary and not fortified.

French forts had existed since colonial times. These were small, but permanently fortified. However, French forts were generally not adequate for combat conditions in the 1960s war years.

A "strategic hamlet" was lightly fortified and controlled by local militia. In Vietnam, a "hamlet" was a discrete portion of a "village" which might cover several kilometers.

Finally, there were "night defensive positions," (NDP)  occupied by infantry for just one night. Of course, it might include foxholes and possibly some claymore mines, but was otherwise not heavily fortified.

Firebase Combat Role

The concept of a firebase or FSB was to house an artillery battery that could support infantry operations within its range. For the 105mm howitzers, this range was 11000 meters. So, an FSB could support an area 22000 meters, or 22 km in diameter. Infantry units assigned to this region could patrol and conduct operations while relying on artillery support.

Naturally, higher caliber guns extended the radius of operations. And, by locating multiple firebases spaced apart from each other, an entire district could be covered by artillery fire, provided the spacing was within two howitzer ranges. (22 km minimum)

Even if they were spaced 22 km apart, the number to cover all of South Vietnam, 1000 km long, would not have been manageable. Therefore, MACV forces had to concentrate their operations and FSBs on certain select areas at any given time.

Layout and Defenses

Naturally, the NVA developed sapper units to attack and destroy firebases. So a firebase had to have adequate defenses. The location was usually set in a clear area, with at least 100 meters clear all around the firebase. This gave garrison defenders good line of sight to attackers. Often, the jungle had to be cleared by explosives or bulldozers. The perimeter usually had trenches with bunker strongpoints, and elevated observation towers at intervals. Wire barriers, (barbed or concertina wire,) surrounded the trenches. The total firebase size was at least 200 to 300 meters in diameter.

Within the firebase perimeter, there was an LZ, command and communication bunker, fire direction control (FDC) bunker, and the gunpits. Usually an artillery battery of six guns were assigned, so firebases typically had six gunpits. Living quarters for artillery crews and infantry were also included in the complex. Where infantry "D" companies existed, they might be used for the defensive garrison.

Each battery position, including gunpits and the FDC were arranged in circular fashion to allow for the "6400 mil concept" or ability to fire quickly in any direction. Often, there would be additional berms, sandbags, and even wire obstacles around gunpits to fortify them as "inner" defenses. Each gunpit had ammunition racks, an HE shell bunker, crew quarters, a powder pit and bunker, and a fire barrel.

FSB Hill 4-11

A typical Vietnam era firebase was FSB Hill 4-11, which was active near  Quang Ngai City, during 1969 - 1970. It was the headquarters for the 3rd Battalion, 1st Infantry. The artillery unit was Delta battery, (M102A1 105mm Howitzers) 6th Battalion, 11th Artillery.

See numbered items in Yellow:

1   Command and Communication Center

2   Landing Zone, LZ

3   Gunpit

4   FDC Bunker

5   Defensive strongpoint

6   Clear fire zone

Conclusion

The artillery fire support bases played a significant role in US combat operations in Vietnam. It is important for Campaign Series wargamers to understand how they fit into the US strategy for conducting the war. They had the advantage of providing artillery support over a large operating area. They were vulnerable to NVA sapper attacks in particular, and so had to have adequate fortifications, and garrison troops to support them.

References

"Vietnam Firebases 1965-73," Randy E M Foster, Illustrated by Peter Dennis

I get the impression that Hack really liked having artillery support. He discusses its need in his Vietnam Primer. Apparently, it was effective against VC tunnels.

mpaign Series Vietnam | Hack's Hardcore Hints

Comments are closed.